Rapid Drying for a Faster Time to Tile

HYDRO BAN Waterproofing Membrane

HYDRO BAN is a thin, load bearing waterproofing/crack isolation membrane that DOES NOT require the use of fabric in the field, coves or corners. HYDRO BAN is a single component self curing liquid rubber polymer that forms a flexible, seamless waterproofing membrane. HYDRO BAN bonds directly to a wide variety of substrates.

• Allow for flood testing in 2 hours at 21°C or higher¥
• Does not require the use of fabric.*
• Bonds directly to metal, PVC and ABS plumbing fixtures only
• Thin; only 0.5–0.8 mm thick when cured
• Changes in colour from a light sage to an olive green when cured
• Anti-fracture protection of up to 3 mm over shrinkage and other non-structural cracks
• “Extra Heavy Service” rating per TCNA performance levels (RE: ASTM C627 Robinson Floor Test)
• Exceeds ANSI A118.10 and A118.12
• IAPMO approved
• Contains Microban® antimicrobial product protection
• Rapid drying for a faster time to tile
• Lighter colour for ease of inspection
• Safe—no solvents and non-flammable
• Install tile, brick and stone directly onto membrane

* For gaps 3 mm or less see DS 663.5 for complete instructions

¥ Refer to cautions section for more information on curing

Click here for more information on HYDRO BAN.

Airless Spraying of HYDRO BAN:

In addition to the conventional means of applying HYDRO BAN, the airless spraying technique can be used as an alternate means of application. HYDRO BAN can be effectively sprayed to increase productivity up to 3x or 4x on large projects. Any airless sprayer can be used which will deliver up to 3300 PSI (22.8 MPa) using a maximum tip size of 0.79 mm.

See TDS410 for further information on the application of HYDRO BAN with an airless sprayer.